The boat featured is not currently for sale by Boatshed. The boat information and images presented are part of Boatshed’s back catalogue of the 25,000+ boats we have listed in the last 20 years and appear here for general information and guidance purposes about Boatshed and our boat selling systems and services

Aluminium Blue Water Cruiser Project

New Quality Fittings Included
£0 Sold / Unavailable
  • Boat REF#  ·  255601
  • LOA  ·  11.58m
  • Year  ·  2012
  • Construction  ·  Aluminium
  • Underwater profile  ·  Long keel
  • Engine  ·  1 x Diesel 80hp, Perkins M90 (2015)
  • Lying  ·  Plymouth, Devon, UK (by appointment only)
Boatshed Plymouth
Boatshed Plymouth

The boat featured is not currently for sale by Boatshed. The boat information and images presented are part of Boatshed’s back catalogue of the 25,000+ boats we have listed in the last 20 years and appear here for general information and guidance purposes about Boatshed and our boat selling systems and services

Extra Details

Designer Ganley Yachts, New Zealand
Builder Previous Owner, Isle of Wight
Lying Plymouth, Devon, UK (by appointment only)
Fuel capacity 800.0 ltr Total - 2 Tanks
Water capacity 600.0 ltr Total - 5 Tanks
Holding tank capacity 60.0 ltr Total - 1 Tanks

Mechanical

Engine 1 x Diesel 80hp
Engine make and model Perkins M90 (2015)
Engine Hours engine1= 1
Engine Cooled Indirect
Steering Tiller
Drive Shaft
Fuel consumption (approx) Not Recorded

Perkins Factory reconditioned engine £5000
New drive shaft
Batteries will be chargeable by engine & shore power

Possible to change steering from tiller to wheel - steering parts excluding wheel available.
Batteries charged by engine and shore power

Dimensions

LOA 11.58m
LWL 10.06m
Beam 3.35m
Draft Min 2.00m
Draft Max 2.00m
Displacement 5,000kg
Headroom 1.91m
Storage Ashore

Electrical Systems

24 volt battery,

Construction

Construction Aluminium
Underwater profile Long keel
Finish Aluminium finish

Displacement figure approximate

Hull plate is 6.5mm marine grade Aluminium
Frames are 75 x 40" L section with doublers at 900mm centres

The owner believes there is the following outstanding work to be done on this project:
'The engine installation needs to be finished including the exhaust system, fuel system and controls
The shaft seal needs to be installed with for example a Tides marine seal
The prop needs to be obtained
The Ballast needs to be fitted, washer punchings (3 tons required) and then the bilge pumps etc. can be connected (onboard ready)
Weld on the hand rails
The wiring is all there ready for connection."

Accommodation

Handbasin 1
Heads 1 heads (Manual)

Double sink in galley
Heads fitted & plumbed with holding tank

Accommodation

Sink
Refrigerator
Pressurised water system
Non-Smokers

Double sink in galley
Heads fitted & plumbed with holding tank

Deck Gear

Warps

1 anchors
(Delta 20kg)
60.00m of chain

Safety Equipment

5 bilge pumps (1 manual / 4 Electric)

Bilge pumps need to be fitted

Broker's Comments

This sturdy partially fitted out aluminium hull has the potential to become a fantastic blue water cruising vessel, power or sail (the previous owner planned to fit out as power but this can be changed).

The unique stern was originally constructed by a previous owner to house a salvage winch for retrieving treasure in the Pacific Ocean.

A great deal of the expensive internal work has already been carried out by a professional engineer. She comes fitted with an 80hp Perkins M90 at a cost of £5k, which is fully reconditioned and unused from the Perkins factory. A new prop shaft is also fitted and she has plenty of brand new tankage fitted for fuel, water and a holding tank for waste.

The galley is partially fitted with a double sink and fridge. The heads/wet room is also a work in progress with a new toilet & sink whilst a shower still needs to be purchased & fitted.

All Tru Design skin fittings are ABYC approved & rated H-27 standard for aluminium hulls.

Also included are 4 electric bilge pumps plus 1 manual, a battery charger, fresh water pumps and chain plates if needed.

This is a great opportunity to acquire a very reasonably priced, unused, aluminium hull and to finish it to your own desired specification, power or sail.

These boat details are subject to contract.
Note: Offers on the asking price may be considered.

This Aluminium Blue Water Cruiser Project has been personally photographed and viewed by Billy & Jo Hallam of Boatshed Plymouth. Click here for contact details.
Where the particulars herein give details of a boat, whether new or used, they are intended to give a fair description of the vessel but are not guaranteed as accurate or complete. They shall not form part of any offer or contract for the sale of the vessel. The prospective purchaser is recommended to independently check the particulars and the vessel. The vendor is not selling in the course of a business unless otherwise stated. Personal property is excluded from the sale of the vessel unless specifically included in the listing specification above or in a purchase contract. Personal property may be equipment or gear not permanently attached to the vessel including but not limited to: artwork, entertainment equipment, fishing equipment, TV receivers, recreational equipment, kayaks, tools, and personal appliances. Photos that may incidentally depict owners' personal property do not convey that such items are included in the sale of the vessel unless such items are specifically listed herein. At all times, where the particulars herein give details of a new boat and/or a new boat to be supplied/built by a builder/manufacturer, or a boat to be chartered, via our introduction, we do not guarantee or assume responsibility for the accuracy or reliability of any information offered by third-party companies in respect thereof including without limitation new boat builders/manufacturers, charter companies and/or companies/businesses which are ‘Friends of Boatshed’. We shall not be responsible for, or party to, any transactions, contracts or agreements between you and such third-party providers of products or services and it is incumbent upon you to verify such details direct with such entities and contract with them at your sole discretion and on terms that you agree.

Comments 0

Please note this comments section is public. Please do not post your personal details here. Please read our commenting guidelines before posting.

Be the first to leave a comment or ask a question...
You must be logged in to leave a comment.
Login or register for free